Home

Yay! You're now following replacement rocker panels in your .

1999-07 Chevy Silverado and GMC Sierra Universal 4dr Extended Cab Outer Rocker Panels (Pair)

$79.98


I've just not had to replace rocker panels before

Whether you've got a , , or restorable classic, we stock quality replacement rocker panels from reputable manufacturers such as Goodmark, Sherman, and . These high-quality brand names specialize in producing OEM-quality body parts at lower-than-OEM prices.



After the Rockers, Cab Corners, and Fenders were on, I started on the Floor Supports. I could see the outline of them on the floor inside the Cab. I was installing a body lift along with repairing the rust, since I had to remove rubber body mounts to weld. Getting out the bolt under the cab on each side was a slight problem. Seemed the nuts were inside the hollow of the supports. When I tried to loosen them the nut inside turned. Since I could see the outline on the floor inside, I drilled a 1" hole, to gain access to the nuts. I then cut out a 2" x 2" square section around the hole I drilled. The nuts were square (4 point), and just a solid chunk of rust. No way they'd come out, so I used a 4 1/2" Grinder to grind off the heads of the bolts. I then drove them through with a drift, and pulled them out from inside the Cab. It wasn't a quick easy job. On the Passenger side, I found the Cab Floor Support Channel was crushing, since the rust made the steel that much thinner, and weaker. The Cab was sagging on that side, and now I found out why.
Since I didn't have a Cab Floor Support Channel laying around, and didn't order one, I tried another idea. I cut a piece of 1/8" x 2" x 3/4" square edge channel steel. I hammered it inside the old Cab Floor Support Channel. The flat plate on top of the channel, was rotted as well. I replaced it with a rectangular piece of 3/16" steel plate, and welded it in. I then drilled for the Body Mount bolt to go through. I welded on the new Cab Floor Support, and Inner Rocker Panel.

Notes:
* To replace the Rocker Panels, the Fuel Tank(s) must be removed, as well as the carpet, and seat(s).

* To replace the Cab Corners, the Bed must be unbolted from the Chassis, and moved back enough to weld on the Cab Corners, in addition to removing the carpet, seat, and interior trim.

* To weld on the front edges of the Rocker Panels to the Cab, the front Fenders must be removed.

How to Replace Rocker Panels in Cars

  • Jeep Cherokee Rocker Panel Conversion
  • Jeep XJRocker Panel Replacement
  • Jeep Cherokee XJ Interior
  • Jeep Liberty Replacement Rocker Panels
  • 2000 Jeep Cherokee Rocker Panels
  • Jeep Cherokee Rocker Panel Covers
  • Jeep Grand Cherokee Rocker Panels
  • Jeep ZJRocker Panels
  • Rocker Panel Repair Kit
  • Rocker Panel Repair
  • Jeep Cherokee Header Panel

Outer Driver Side Replacement Rocker Panel OE Style New | eBay

If the rocker panels in your car have developed too much rust over the passage of time, you should probably replace them instead of trying to remove the rust. Fortunately, replacing rocker panels is something you can do at home with too much hustle.

If the rocker panels in your car have developed too much rust over the passage of time, you should probably replace them instead of trying to remove the rust. Fortunately, replacing rocker panels is something you can do at home with too much hustle.