Today on our 2008 Jeep Wrangler Unlimited, we're gonna be installing the Westin Platinum Series Oval Nerf Bars, part number 21-3295. Weve gone ahead and laid out all 6 of the mounting brackets. As each of the brackets have a specific location that they must be installed. Let's go ahead and go over with each of the brackets look like for each of the 6 locations. We'll start here at the passenger side rear and you notice that this one has an angle cut to it on this piece right here. So this right here is the passenger side rear bracket.
Replace the step pad for your Westin Platinum Series 3" diameter, round step bar with this non-slip polymer pad. The UV-resistant material will not crack or fade. Barrel clips are included.
Well go ahead and begin here at our rear bracket on the passenger side. Now, we will go ahead and move to the middle bracket. And now for the forward bracket. Now, once you have the forward bracket installed, you want to make sure that this little tab section here is facing towards the rear of the bracket. You want this to be like this on all three. The hardware that will be using to mount the tube step to our brackets is this M8 bolt and M8 lock washer and an M8 flat washer, it will go just like that. Now, let's go ahead and set our tube step on top of each of the brackets. Heres the mounting locations that are located underneath and we will go ahead and install our hardware just hand tight for now, until we get all of our adjustments made. We will go ahead and take our socket wrench and we will snug down the bolts that hold the tube step to the brackets. You want to make sure that you have the tube step position where you want to it as well as trying to get to it as level as possible. Youll then go back and torque to the manufacturers specification. Everything you did on the passenger side of the vehicle, you will repeat the same process over on the drivers side. And with that, that will do it for our installation on our 2008 Jeep Wrangler Unlimited of the Westin Platinum Series Oval Nerf Bars, part number 21-3295. .
Westin Platinum Series Nerf Bars are made of 3 inch diameter round stainless steel and are vehicle specific. Step design and mounting technique varies by application with mount kit included. Unique to the Platinum Series, each application is offered in a chrome finish with a lifetime warranty.